i used a cube and extruded all the sides over and over again , i then took the bridge tool and connected every second extrude
cube default size 200x200 extrude 1000 extrude 200 and repeat after that i selected all the 200 extrusions and extruded them as needed, after that i used the bridge tool to connect them all again very simple but also very nice looking hope this was at least a little helpful
cube default size 200x200
extrude 1000
extrude 200
and repeat
after that i selected all the 200 extrusions and extruded them as needed, after that i used the bridge tool to connect them all again
very simple but also very nice looking
hope this was at least a little helpful